TEST_TYPE: manual

INPUT: 1. Change the 'Scan To...' TIFF orientation setting to 'Use TIFF Orientation Tag (Faster image processing, special image viewer may be needed)'. Note: Steps to do that are documented in the previous test case.
2. For 'Scan To...' service, go ahead and enable the job log .XST (if not already enabled in the previous test case) through: WebUI->Properties->Services->Scan To...->Setup->Defaults (tab). Select 'Edit' under Report Options and enable .XST job log. Save changes.
3. Obtain 2 TIFF viewers, one that understands tagging (e.g. Faststone Image Viewer 4.6) and one that does not (e.g. MS Office Document Imaging version 2007 or Microsoft Office Picture Manager 2006).
4. Add at least one Public Address Book contact (through WebUI->Address Book) that is configured for Scan to Destination as well. Note: this will enable the Scan To... servicer at the LUI. Note: same contact can be used as in the previous step.

FILES:

AUTOMATION_GROUP:

AUTOMATABLE: yet_to_be_analyzed

ACTION_TO_BE_DONE:

CONSTRAINTS_DAR: Imp_98 . NA  Done By Previous Analysis

TESTCASE_MODIFICATION_REQUIRED: no

MFF: 8647 - 8651

SPEC: FS 46.050 Network Scanning Image Settings; FS 46.020 Scanning Services Coherency; VFA 46 020 Scan Performance TIFF Rotation Method

TESTCASE_FAMILY:

HISTORY:

REASON_FOR_AUTOMATABLE:

CDATE: 1697204918

TESTCASE_APPROVALS:

TESTCASE_STATE:

OUTPUT: When scanning tiff jobs using TIFF Orientation Tag, there will be a decrease in processing time.
Images viewed with a viewer that supports TIFF Orientation tag, will display correctly. Other 'non-supporting' viewers will not, the image rotation may be incorrect.
Attribute 'RotateTIFFUsingTag' must be present in the Job Log (.XST) along with the corect value. In this case it shall read 'True' due to TIFF rotation feature being enabled.

RESOURCE_HW:

MDATE: 1697204918

APPROVED_SPAR:

TEST_CASE_TYPE: full_test

TC_WORK_LOCATION_CAT: work_from_home_with_office_support_tc

AUTHOR: r77LRCL3

GROUP: scan

MUSER: r77LRCL3

SPEC_TAG: [46.020.006] (FT-14212) {DY 1.0} Table 6.05.01.01 1 Default image settings Requirements 
[46.020.009] (FT-14212) {DY 1.0} Table 6.05.01.01 1 Factory Default Settings 
[46.050.075] (FT-14502) {DY 2.1} The supported TIFF Rotation Method settings are the following:
•Rotate Scanned Image (disabled) - slower image processing, viewer independent
•Use TIFF Orientation Tag (enabled) - faster image processing, may be viewer dependent 
[46.050.076] (FT-14502) {DY 2.1} If the TIFF Rotation Method is disabled then the TIFF Orientation Tag shall be set to 1; no rotation 
[46.050.077] (FT-14502) {DY 2.1} If the TIFF Rotation Method is enabled then the TIFF Orientation Tag shall be set to a value that reflects the rotation required; see Supported TIFF Tags (section 5.3) 
[46.050.078] (FT-14502) {DY 2.1} If the TIFF Rotation Method is enabled and the image is B&W then the TIFF Orientation Tag shall be set to 1; no rotation 

SPEC_NUM:

PROCEDURE: With TIFF orientation settings changed to: 'Use TIFF Orientation Tag (Faster image processing, special image viewer may be needed)' go ahead and verify the functionality match its settings.
1. To verify the functionality, through LUI, go ahead and perform a 'Scan To...' scan job using the same Address Book contact as in previous test case. Job Type: Scan a 1-page 8.5x11 size original via the DADH using LEF (long edge feed). Make sure to select TIFF file format if not already selected.
2. Log into the server and look at the output in both viewers (that understands tagging and that does not). Output may be incorrect (or with incorrect orientation) in viewer that does not interpret tags (e.g. MS Office Document Imaging version 2007 or Microsoft Office Picture Manager 2006). \
Note: in order for 'MS Office Picture Manager' to view successfully the scanned file, it may be necessery to change the ScanTo... compression settings for TIFF Color Compression from 'TIFF Specification Supplement 2...' to 'TIFF 6.0 (old JPEG)'. To do so, navigate back to WebUI and change the Compression Settings for Scan To... service under Defaults->Compression Capability for TIFF Color Compression. Run the same job again and validate the outcome.
3. Perform the same test using the same original scanned via the DADH using SEF (short edge feed). Same outcome is expected.
4.Verify job log (.XST) files contain 'RotateTIFFUsingTag' attributes with correct values. In this case, value should read 'True.'

DEVELOPMENT_COMPLETE_TIME:

ATM_LOCKED: 0

PRECONDITION_TO_BE_DONE:

PO_SIGNOFF_DATE:

APPROVE_SPAR: blank

RELEASE:

TESTCASE_PRODUCT:

FILENAME:

ATM_MCOMMENTS: Copied from "WFAST_Scanning/Testcases/FS_46.020_Scanning_Services_Coherency/24883".

RESOURCE_MEDIA:

COMMONALITY_DETAILS:

PRIORITY: 1

COMMON_FUNCTIONALITY:

APPROVED_QE:

TESTCASE_HEADLINE: Scan To? w/ TIFF Orientation Tag enabled.

TESTCASE_VERSION:

FEATURE:

APPROVE_SE: blank

SPEC_VERSION: 1.0009, 10010, 10011, 1.0

TESTCASE_PLATFORM:

FILEDESC:

PROCESS:

TC_WEIGHTAGE:

COMPLEXITY_OUTPUT_VALIDATION: 0

SKILL_SET: intermediate

TESTCASE_SOURCE: feature_spec

APPROVE_QE: blank

COMPLEXITY_PRECONDITIONS: 0

TESTCASE_STEPS_ARE_RELATED_TO:

APPROVED_SE:

PLANNEDTIMESTAFF: 15

ATM_OWNER: USWU53968

LOE:

ASSOCIATED_TESTCASES:

TRAINING:

ATM_REQLINK: 29EE1C01-8423-1014-921C-B52B8C9F1B27, 29F5B54F-8423-1014-AFEC-AF611C638145, 62CC8482-6FAF-1014-8458-BBF0255E4A1B, 62D45CD0-6FAF-1014-8182-976225CAA5FE, 62D6EACC-6FAF-1014-8AC4-8B685E06F70A, 62D9DD65-6FAF-1014-A76F-A67314119E07

DEVICE_CATEGORY: mfp

SUB_FEATURE:

RESOURCE_CONSUMEABLES:

AUTOMATION_TC_VALIDATION:

QA_TEAM: none

ATM_ID: 363DFA9A-69CF-11EE-B271-C095A3A4F7C5

APTEST_UPDATE_STATUS: no

ATM_REQCOUNT: 6

COMPETENCY: